Eye Zee Eye - Hone Tool
about
I suck at building launchers, and if you do too, here is a tool to help you.
PLEASE NOTE!!!!
Use of this tool will remove any protective coating inside your 37mm launcher barrel.
DO NOT use this tool unless you are in need of additional clearancing. Please be aware your barrel will
wear down more quickly and will need to be replaced sooner. That being said it is a fast solution to barrel
preperation.
- Print all of the files located in the STL folder with at least 3 walls and 15% infill.
- Install any used drill bit at least 3 inches long and 3/16-7/32 in diameter in the tool body using
superglue or epoxy.
(There is no need for the bit to extend beyond the tapered portion of the tool body.)
(Doing so may interfere with the clamp screws.)
- Cut 8 pieces of sandpaper roughly 30mm X 100mm. These pieces should be uniform
- using M3-10 or M3-8 SHCS, install the sandpaper under the clamps, all facing the same direction.
Your tool is now ready to use, enjoy.
Eye_Zee_Eye
files
| File | Extension |
|---|---|
| Eye_Zee_Eye Hone Tool.zip | zip |
versions
Version: 1.0.0 latest
initial upload
about
I suck at building launchers, and if you do too, here is a tool to help you.
PLEASE NOTE!!!!
Use of this tool will remove any protective coating inside your 37mm launcher barrel.
DO NOT use this tool unless you are in need of additional clearancing. Please be aware your barrel will
wear down more quickly and will need to be replaced sooner. That being said it is a fast solution to barrel
preperation.
- Print all of the files located in the STL folder with at least 3 walls and 15% infill.
- Install any used drill bit at least 3 inches long and 3/16-7/32 in diameter in the tool body using
superglue or epoxy.
(There is no need for the bit to extend beyond the tapered portion of the tool body.)
(Doing so may interfere with the clamp screws.)
- Cut 8 pieces of sandpaper roughly 30mm X 100mm. These pieces should be uniform
- using M3-10 or M3-8 SHCS, install the sandpaper under the clamps, all facing the same direction.
Your tool is now ready to use, enjoy.
Eye_Zee_Eye
creator
Metrics
Views
232
Downloads
74
Project Info
release date
Jan 14, 2024
artifact type
Printable project
library category
Printable Tooling
fabrication method
Primarily Printable
fabrication tool
3D Printer
release country
United States
language
English
license
No license
Firearm Info
type
Launcher
caliber
37mm
files
| File | Extension |
|---|---|
| Eye_Zee_Eye Hone Tool.zip | zip |
versions
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
