Glock43 Light Up Stand
These files are oriented properly in cura. You should be able to print
this vertically without using supports for the round spots. The 6 holes on top will
hold x6 - 9mm rounds while omitting your light up through the bullet. The hole in the
back is designed for a short light strip. Im using a 3ft usb powered controlled rgb
led that I cut down. I found this at my local $5 below but amazon has them also!
Print the Back piece using a highter infill because it can tear in half after removing it a bunch.
Its best to insert it once and be finished once your satisfied with your lighting.
++++++++++++++++++++++++++++++++++++++++++++++++
NeutronNickandSpaceBoundTactical
Print Settings
Esun or Inland Brand PLA PLUS+++ preferred
Nozzle 220
Bed 62
++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++++++++++
reddit u/Spaceboundtactical
Odysee SpaceboundTactical
DefCad Spaceboundtactical
https://twitter.com/SpaceBound3DP
Feel Free to share your prints!!
Initial release