Khokhlo Archive (хохлоархив)

Filament Types: PLA, ABS, PETG

Resolution:

Nozzle diameter: 0.4-0.6

Layer height: 0.2 - 0.32

Wall lines count: 3

Infill: 15

Top layers: 3

Bottom layers: 3

Supports: true

Description:

Anti-reflection filter and cap for TR-8

The description was updated on 02/14/2024

We print in the orientation of the details as on the chest

1 product = anti_glare + cap_big + cap_small + grid

This product is printed with supports for anti_glare (inset is an overhang), without a border

Product quality:

make sure that the outer perimeters do not go first when printing

the grid should enter the anti_glare tightly with the rounded side forward and not fall out

hair on the grid SHOULD NOT be, under no circumstances!!!

after printing the first product - check the overall dimensions of the parts (width, length, height, diameter of the main holes) with the dimensions in the slicer or the anti_glare_tr_8.ods table (copy for yourself)

make sure that the product is not fragile. Thin parts of the product should bend a little, and not burst from the slightest pressure. The parts MUST NOT break, crack, delaminate when compressed (you don't want to throw away the parts as a waste)

if you doubt whether the products turned out to be good - contact the product branch or write to the curator (a photo or video of the problem is mandatory)

standard errors:

- MATTE - rather, the temperature is too low and the product may be fragile, increase the temperature, and it is better to calibrate with a temperature tower, but it may be such plastic

- fishing - dry plastic, calibrate temperature, retracts and Linear Advanced

- a problem on overhanging surfaces - increasing the line width to 0.5-0.6 mm, reducing the speed can help

- stratification - check the temperature, flow, increase the width of the layer

- the dimensions do not match the table - check the flow, increase/decrease the part according to the table

we clean, collect, pack, send the lining, edging and support

!!!DO NOT SEND BROKEN!!!

Printing time and product weight are approximate and may vary depending on the choice of printing materials, printer and its settings. These data are indicated for familiarization and understanding of how many resources need to be spent

In the description of the shipment, specify: plastic or parts or plastic products, you can specify "Plastic (product #1234 / 40 pcs)", where # is the task number. DO NOT specify the name of the product!!!

PS: treats or gifts will be a pleasant surprise for boys)))