Khokhlo Archive (хохлоархив)

Filament Types: PLA, ABS, PETG

Resolution:

Nozzle diameter: 0.4

Layer height:

Wall lines count: 3

Infill: 15

Top layers: 3

Bottom layers: 3

Supports: false

Description:

Please read the instructions below carefully.

Choose to download the zip file corresponding to the type of detonator indicated above 👆 in the order.

• VOG - Morozyvo1600-vog.zip

• MD-5 - Morozyvo1600-md5.zip

• KD-8 - Morozyvo1600-kd8.zip

• MDZ - Morozyvo1600-mdz.zip

For example: Type of detonator VOG - download Morozyvo1600-vog.zip

Support: not required.

Brim: for the tail if it is not securely held on the printer's table during printing.

Extrusion width (line width):

• 0.6 - the walls of the body and the tail are higher than the support (recommended, because it will turn out faster and stronger)

• 0.5 - the rest (or the entire print)

Layer height: thread - 0.2, the rest - 0.2-0.3

 Color: any not very bright.

Print the tail with one wall (walls), filling (infill) - 0% or in spiral vase mode.

Auxiliary tools are located in the tools folder. STL files from there you need to print one set per shipment. They are used when filling balls.

For BambuLab printers, instead of STL files, you can use the project for OrcaSlicer 2.0 Morozyvo1600-???.3mf, but check the filament settings and others.

For the VOG detonator type:

If the threaded connection under the VOG is too tight, then use the vog25-key.stl from the tools folder to grind. It will not help, reduce the flow (flow ratio).

If the opposite connections are too loose, try increasing the flow by 1-2%.