Close Quarters Evo Grip, Cutback (CZ Scorpion Evo 3): Laffs Dynamics
A large, curved, forward angle grip for use in close quarters engagements. Has .5mm wrap ridging around the front section.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 6+
Infill: 38%+
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
1x M4 Hex Nut
File | Extension |
---|---|
Close Quarters Cutback Grip (CZ Scorp Evo).zip | zip |
Version: 1.0.0 latest
initial upload
Close Quarters Evo Grip, Cutback (CZ Scorpion Evo 3): Laffs Dynamics
A large, curved, forward angle grip for use in close quarters engagements. Has .5mm wrap ridging around the front section.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 6+
Infill: 38%+
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
1x M4 Hex Nut
1.1K
93
Feb 1, 2024
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
Close Quarters Cutback Grip (CZ Scorp Evo).zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.