RH Beta Holsters and Accessories for 43/43x/48/19/26/17 and possibly others. 48 Added, 8/13/24 All Main bodies slimmed down 1.5-2mm, mag release cutout added to 43/48 models, Added 8/14/24
Holster Bodies should be printed vertically on end with enough walls for solid printing around hardware points (about 6 walls). Infill as desired. Supports are minimal depending on how well you are tuned, and only needed on the overhang below the Trigger pocket, where the Claw would mount.
Clips should all be printed on their side, standing up horizontally.
Claw Arms print laying flat for strength, all walls or walls as desired and 100% infill.
Hardware:
Wide Double Clip
Single Undermount Clip
*This is sets of hardware per clip. If using two single clips, 4 sets of Chicago screws are needed
Holster Tension without Claw
Holster Tension with Claw
*adjust tension until desired retention is achieved. Loctite recommended to prevent loosening.
Puck
Claw Clip
Thank you to Riptide Rails for the great starting point to run with. Stay free and keep those printers running.
File | Extension |
---|---|
D3D Riptide Holster Beta V3.zip | zip |
Version: 1.0.0 latest
initial upload
RH Beta Holsters and Accessories for 43/43x/48/19/26/17 and possibly others. 48 Added, 8/13/24 All Main bodies slimmed down 1.5-2mm, mag release cutout added to 43/48 models, Added 8/14/24
Holster Bodies should be printed vertically on end with enough walls for solid printing around hardware points (about 6 walls). Infill as desired. Supports are minimal depending on how well you are tuned, and only needed on the overhang below the Trigger pocket, where the Claw would mount.
Clips should all be printed on their side, standing up horizontally.
Claw Arms print laying flat for strength, all walls or walls as desired and 100% infill.
Hardware:
Wide Double Clip
Single Undermount Clip
*This is sets of hardware per clip. If using two single clips, 4 sets of Chicago screws are needed
Holster Tension without Claw
Holster Tension with Claw
*adjust tension until desired retention is achieved. Loctite recommended to prevent loosening.
Puck
Claw Clip
Thank you to Riptide Rails for the great starting point to run with. Stay free and keep those printers running.
591
169
Sep 26, 2024
United States
English
No license
File | Extension |
---|---|
D3D Riptide Holster Beta V3.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.