Ghost Gunner M16 / M4 Full Auto Sear Cut Code
about
Use your Ghost Gunner to cut your receiver like you lived in a free country.
Load the above .dd file to cut ONLY a properly located auto sear hole on your receiver.
Correct use of this code requires a 1/8" drill bit and 1/8" ER11 collet (not included with the Ghost Gunner) set up in the machine when prompted to install the 5/32" bit normally used for trigger and hammer holes.
This code should be used ONLY on a receiver with an "M4" FCG pocket milled already. In order to fit an auto sear, the FCG pocket must be cut to "M4" specs (wider than an AR15 pocket). Code for this FCG pocket may be included with this file later.
files
| File | Extension |
|---|---|
| drill-only-sear.zip | zip |
versions
Version: 1.0.0 latest
about
Use your Ghost Gunner to cut your receiver like you lived in a free country.
Load the above .dd file to cut ONLY a properly located auto sear hole on your receiver.
Correct use of this code requires a 1/8" drill bit and 1/8" ER11 collet (not included with the Ghost Gunner) set up in the machine when prompted to install the 5/32" bit normally used for trigger and hammer holes.
This code should be used ONLY on a receiver with an "M4" FCG pocket milled already. In order to fit an auto sear, the FCG pocket must be cut to "M4" specs (wider than an AR15 pocket). Code for this FCG pocket may be included with this file later.
creator
Metrics
Views
48.1K
Downloads
2.3K
Project Info
release date
Apr 18, 2020
artifact type
library category
fabrication method
fabrication tool
CNC Machine
language
English
license
No license
version hash
QmQNArL9ZkuZTLF46CuKq6cM3ki94B1pYiHjd9LNnWgrfZ
files
| File | Extension |
|---|---|
| drill-only-sear.zip | zip |
versions
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
