# +4 and +6 OEM Glock Mag Extensions
#### Version
1.0
9/1/18
#### Credits
Find me in the internet for more shennanigans.
Created by CTRL+Pew
@ctrlpew everywhere
http://www.ctrlpew.com
#### Tested
Yes.
Repeated drop tests from 3ft and 5ft onto cement. 17 drop of final version before failure using PLA+.
Video available
https://www.instagram.com/p/B16me8Ogk-L/
https://www.instagram.com/p/B16mtsDAB-J/
#### Descriptions
These files contain the design for a 3D printed Glock magazine extension. This design requires an M4 screw to lock the extension on the magazine. Any M4 screw will work given sufficient length 5 mm. Personally I like the grub screw.
##### Features
Dramatically curved body to allow for easy finger gabbiness, expediting the recharging of your freedom dispenser. Utilizes all the parts from the OEM mag except the floor plate.
Additional Variants and styles coming soon.
####Print Instructions
Walls:5
Ceiling:5
Floor:5
Infill: 60%
#### Installation Instructions
Pick your body and print it vertically (locking lips up) with supports everywhere. Once printed disassemble your OEM magazine. Drop the locking plate, nipple up, into the extension. With the spring and follower assembled and inserted into the OEM mag body; insert the spring into the extension(Render/3) and seat the locking interface in the rear half of the extension. Slide the magazine body forward to seat it and tighten down the M4 screw. (This screw should not go all the way in. That's by design. The body of the screw is what locks the extension on to the magazine)
** Some beta testers have reported needing to stretch their magazine spring slightly to accommodate this.
#### Disclaimer
The creator makes no guarantees that this will function over time or under pressure. Use at your own discretion. The creator also makes no claim that this is legal for you in your present juristiction. Check your local laws.
I tried to buy this...then it told me security settings adjusted...now I can't buy anything on the site