12GA Simulator Blank Round: Laffs Dynamics

A 2 3/4in shotshell designed for function and sound simulation. Uses the common 209 shotshell primer for sound simulated effect. Can be used as an 

anti-avian device. (The sound of firing the shell to scare off birds from a general area; do not aim at birds.)

Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 220C 

Bed: 56C 

First Layer Print Height: .20mm 

Standard Layer Height: .16mm

Wall Thickness: .40mm

Wall Perimeters: 7+

Infill: 70%+

Support Material Percentage: 20%

Print the front and rear sight mounts on their front faces, and the rear sight drift on it's rear, flattest face.

Hardware Needed: 

1x 209 Shotshell Primer

WARNING: Not designed to be used with anying other than the 209 primer. Do NOT fill the simulator round with any payload/projectile, as this 

will cause structural failure of the design and may cause injury/death. I take no responsibility for misuse, mishandling, and(or) failure to 

properly construct the design that may lead to injury or death. 

Do not point a firearm loaded with this (or any) ammunition, regardless of the fact this designed ammunition has no projectile.