Mod Mag 20 V1.1.2(Scorpion Evo 3): FFFTech/FFFTechnology

A modification of IMA's (Insertmeow) Scorpion Evo 3 20rd magazine design. 

This magazine variant is 10mm shorter; closer to CZ's OEM 20rd mag. Has the pocketed rib running down the frontal section of the mag similar in aesthetic style to OEM, as well as horizontal struts on the mag's rear section for added rigidity. The baseplate is thicker than the IMA original design, and has a floorplate with a larger lock tab for better baseplate retention when dropping the mag on a hard surface. 

Overall has slightly different external geometry below the feed tower (Does not affect feed reliability.) with chamfered corners, compared to the original's rounded corners. (Chamfers also slightly rounded.) Has Laffs logo on the bottom - front of the design. 

IMA's logo has been retained on the mag body, as well as using the same follower. The feed tower's geometry has not been changed, due to the original design already feeding reliably. 

Update V1.1.2: Added HEX texture magazine body. Added specific print instructions for magazine body print orientation and blocking support structures from texture and logo details. An image of proper print orientation has been included in the IMAGES folder. 

Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 225C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .18mm
Wall Thickness: .40mm
Wall Perimeters: 7+
Infill: 50%+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%

After loading the mag body into your preferred slicer software, tilt the design backwards 25deg for better layer adhesion. (Seen in IMAGES folder included in the data pack.)

Use support blockers on any embossed mag body texture, the mag body's IMA logo, and caliber designated text. 

Hardware Needed: 

1x Scorpion Evo 3 Spring (20rd length)

Accreditations:

Insertmeow/IMA: Developer of AWCY?'s Scz0rpion magazine; which was the base model this design was built off of.