3FTech Gripstop by FFFTech/FFFTechnology Is it a undersized foregrip? Is it an oversized handstop? I don't know to be honest, so I'm just gonna say it's both! The foregrip/handstop/wHat has ridging down it's front to allow the support hand to rest against/grip the design with greater traction than say, if it was smooth. Printer Used: Monoprice Maker Select Plus Filament Used: PLA+ Print Settings: Extruder: 210C Bed: 56C First Layer Print Height: .20mm Standard Layer Height: .14mm Wall Thickness: .40mm Wall Perimeters: 4 -5 Infill: 25% Infill Pattern: Gyroid Material Flow: 100% Support Material Percentage: 30% Print the Gripstop upside-down. Hardware Needed: 2x M5x10 Hex Socketed Machine Screw/Bolt 2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
File | Extension |
---|---|
3FTech Gripstop.zip | zip |
Version: 1.0.0 latest
3FTech Gripstop by FFFTech/FFFTechnology Is it a undersized foregrip? Is it an oversized handstop? I don't know to be honest, so I'm just gonna say it's both! The foregrip/handstop/wHat has ridging down it's front to allow the support hand to rest against/grip the design with greater traction than say, if it was smooth. Printer Used: Monoprice Maker Select Plus Filament Used: PLA+ Print Settings: Extruder: 210C Bed: 56C First Layer Print Height: .20mm Standard Layer Height: .14mm Wall Thickness: .40mm Wall Perimeters: 4 -5 Infill: 25% Infill Pattern: Gyroid Material Flow: 100% Support Material Percentage: 30% Print the Gripstop upside-down. Hardware Needed: 2x M5x10 Hex Socketed Machine Screw/Bolt 2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
8.5K
653
QmdzRCYSssrFGjyFefBE8LrZJcWva8CzcVq1RHLghvnVDV
File | Extension |
---|---|
3FTech Gripstop.zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.