10/22 Snoot FS-Comp: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .18mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 8
Infill: 100%
Infill Pattern: Gyroid
Material Flow: 100%
Hardware Needed:
1x M3x16 Set Screw
SAFETY NOTE: Due to this design coming into contact with hot metal and gasses, it's HIGHLY recommended to
print the design, and use Lost PLA Casting in metal for the finished object. The printed version CAN be
used, but should not be expected to retain structural rigidity for more than a few dozen rounds fired.
File | Extension |
---|---|
10-22 Snoot FS-Comp.zip | zip |
Version: 1.0.0 latest
initial upload
10/22 Snoot FS-Comp: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .18mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 8
Infill: 100%
Infill Pattern: Gyroid
Material Flow: 100%
Hardware Needed:
1x M3x16 Set Screw
SAFETY NOTE: Due to this design coming into contact with hot metal and gasses, it's HIGHLY recommended to
print the design, and use Lost PLA Casting in metal for the finished object. The printed version CAN be
used, but should not be expected to retain structural rigidity for more than a few dozen rounds fired.
975
137
Apr 05, 2023
Stereolithic object, Printable project
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
10-22 Snoot FS-Comp.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.