47-11 AKM Grip: FFFTech/FFFTechnology
Grips for AK pattern / AKM rifles; with similar overall geometry of Browning 1911 pistol's grip.
Two variants are available, each with two subvariants:
OEM and aftermarket full sized 1911 grip panels, as well as FFFTech 1911 grip panels are compatible; and are a drop in fit.
(Integrated Panel subvariant grips DO NOT use grip screws, nor grip screw bushings.)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 55C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 25%+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside down
Support Material ONLY needed for the grip screw bushing ports, and below the INTEGRATED grip panels. Use the support blocker setting in the preferred slicer program for everywhere else within the model.
Hardware Needed:
1x OEM AK Grip Screw
4x (OPTIONAL) 1911 Grip Screw Bushings
4x (OPTIONAL) 1911 Grip Screws
Notes:
1) When installing grip screw bushings, use RED Loctite and let cure for at LEAST 24 hours before grip panel installation.
File | Extension |
---|---|
47-11 AKM Grips.zip | zip |
Version: 1.0.0 latest
Initial release
47-11 AKM Grip: FFFTech/FFFTechnology
Grips for AK pattern / AKM rifles; with similar overall geometry of Browning 1911 pistol's grip.
Two variants are available, each with two subvariants:
OEM and aftermarket full sized 1911 grip panels, as well as FFFTech 1911 grip panels are compatible; and are a drop in fit.
(Integrated Panel subvariant grips DO NOT use grip screws, nor grip screw bushings.)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 55C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 25%+
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside down
Support Material ONLY needed for the grip screw bushing ports, and below the INTEGRATED grip panels. Use the support blocker setting in the preferred slicer program for everywhere else within the model.
Hardware Needed:
1x OEM AK Grip Screw
4x (OPTIONAL) 1911 Grip Screw Bushings
4x (OPTIONAL) 1911 Grip Screws
Notes:
1) When installing grip screw bushings, use RED Loctite and let cure for at LEAST 24 hours before grip panel installation.
1.7K
178
May 09, 2022
3D Printer
United States
English
QmQQcz1Hi2QHj2n3WAnCfe91fCyZHY3FbxsCQarwcEXPDF
File | Extension |
---|---|
47-11 AKM Grips.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.