Origin Grip (CETME-C)
about
Origin Grip (CETME-C): Laffs Dynamics
First of Laffs Dynamics made CETME-C grips. Finger grooved front section with a rounded backstrap.
Max width: 29.4mm
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Perimeters: 8+
Infill: 50%+
Infill Pattern: Gyroid
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Needed:
1x CETME Grip Screw
files
| File | Extension |
|---|---|
| Origin Grip (CETME C).zip | zip |
versions
Version: 1.0.0 latest
Initial release
about
Origin Grip (CETME-C): Laffs Dynamics
First of Laffs Dynamics made CETME-C grips. Finger grooved front section with a rounded backstrap.
Max width: 29.4mm
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Perimeters: 8+
Infill: 50%+
Infill Pattern: Gyroid
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Needed:
1x CETME Grip Screw
creator
Metrics
Views
1.8K
Downloads
190
Project Info
release date
Nov 09, 2022
artifact type
library category
fabrication method
fabrication tool
3D Printer
release country
United States
language
English
license
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
files
| File | Extension |
|---|---|
| Origin Grip (CETME C).zip | zip |
versions
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
