Laffs M-Lok Slot Covers: Laffs Dynamics
Basic bitch M-Lok slot covers, tapered and rounded for comfort in the hand.
Comes in three variants:
Printer Used: Ender 3 V2
Filament Used: PLA+
First Layer Print Height: .20mm
Standard Layer Height: .16mm - .20mm
Wall Thickness: .40mm
Wall Perimeters: 4+
Support Material Percentage: 18%
Print the AFG upside down.
Use support blockers; as the inside of the foregrip is semi-hollow.
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
(Only one of each hardware part needed for the single slot cover.)