Freedom Dev Co Printable MAC-11 Upper
about
The Freedom Co Mac Upper is a printable MAC-11 upper design. The printable upper shell is combined the following parts to complete the upper:
- MAC-11 bolt
- MAC-11 barrel
- 2x Freedom11 trunnions by 1776 Supply
- Allthreads, lock nuts and other hardware
A complete build kit containing all required hardware listed above, as well as the hardware for the Project Obsidian lower, can be purchased from 1776 Supply Co: https://www.1776supplyco.com/product/limited-edition-obsidian-complete-build-kit/
Instructions for assembling this upper can be found on page 5 of the Project Obsidian Guide included in this release.
This upper can be used with several lower designs, including:
- Project Obsidian
- MacMommy
- Frank and Beans
- Project Lotus
At this time this upper is not considered compatible with designs that use aftermarket uppers (such as the MacDaddy, Mac n' Cheese, Sumac, etc.) - however, it may be possible to create a special adaptor which will allow the use the Freedom Co Mac Upper with these designs.
files
| File | Extension |
|---|---|
| README.txt | txt |
| F.C. PRINTABLE MAC11 UPPER RECEIVER.stl | stl |
| ! PROJECT OBSIDIAN - GUIDE !.pdf |
versions
Version: 1.0.0 latest
Initial release
about
The Freedom Co Mac Upper is a printable MAC-11 upper design. The printable upper shell is combined the following parts to complete the upper:
- MAC-11 bolt
- MAC-11 barrel
- 2x Freedom11 trunnions by 1776 Supply
- Allthreads, lock nuts and other hardware
A complete build kit containing all required hardware listed above, as well as the hardware for the Project Obsidian lower, can be purchased from 1776 Supply Co: https://www.1776supplyco.com/product/limited-edition-obsidian-complete-build-kit/
Instructions for assembling this upper can be found on page 5 of the Project Obsidian Guide included in this release.
This upper can be used with several lower designs, including:
- Project Obsidian
- MacMommy
- Frank and Beans
- Project Lotus
At this time this upper is not considered compatible with designs that use aftermarket uppers (such as the MacDaddy, Mac n' Cheese, Sumac, etc.) - however, it may be possible to create a special adaptor which will allow the use the Freedom Co Mac Upper with these designs.
creator
Metrics
Views
7.6K
Downloads
699
Project Info
release date
Jan 24, 2023
artifact type
library category
fabrication methods
fabrication tool
3D Printer
release country
United States
language
English
license
No license
files
| File | Extension |
|---|---|
| README.txt | txt |
| F.C. PRINTABLE MAC11 UPPER RECEIVER.stl | stl |
| ! PROJECT OBSIDIAN - GUIDE !.pdf |
versions
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
