DYNAMIC DONG (Circumcised) M-Lok AFG: FFFTech/FFFTechnology
A foregrip that mimics the PM md. 63's unique forward-pointing front handgrip, known to many as the "Dong" grip, except people seem to like cutting these partially off... you could say *just the tip*.
Instead of cutting off the foresk- I mean the end of the foregrip off, this has been designed to already have a short, slanted bottom. And since this is much shorter than the original DYNAMIC DONG, I can legally call this an angled foregrip without the ATF being a bunch of basic bitches about it.
IT"S ANGLED FORWARD, FED BOIS!
This design is created to mount to M-Lok, essentially allowing attachment to any compatible forend on AKs; and any other weapons with M-Lok slotted forends.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 55C
First Layer Print Height: .18mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 4 - 5
Infill: 22%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 30%
Print the cut dong upside down.
Hardware Required:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
File | Extension |
---|---|
Dynamic Dong (Circumcised).zip | zip |
Version: 1.0.0 latest
DYNAMIC DONG (Circumcised) M-Lok AFG: FFFTech/FFFTechnology
A foregrip that mimics the PM md. 63's unique forward-pointing front handgrip, known to many as the "Dong" grip, except people seem to like cutting these partially off... you could say *just the tip*.
Instead of cutting off the foresk- I mean the end of the foregrip off, this has been designed to already have a short, slanted bottom. And since this is much shorter than the original DYNAMIC DONG, I can legally call this an angled foregrip without the ATF being a bunch of basic bitches about it.
IT"S ANGLED FORWARD, FED BOIS!
This design is created to mount to M-Lok, essentially allowing attachment to any compatible forend on AKs; and any other weapons with M-Lok slotted forends.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 55C
First Layer Print Height: .18mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 4 - 5
Infill: 22%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 30%
Print the cut dong upside down.
Hardware Required:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
3.3K
Nov 20, 2021
United States
English
QmZFP3m9VAktDjUuDxx7dDdwE6xcK65Nfa4afjm24hudzW
File | Extension |
---|---|
Dynamic Dong (Circumcised).zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.