This is a housing and filament guide for Artillery Sidewinder to upgrade the filament runout sensor.
I sourced the sensor from here: https://www.partsbuilt.com/filament-runout-sensor-photoelectric-sidewinder-x1-x2-genius-pro-artillery/
Designed to feed from a bowden tube.
Test printed out of PCTPE
May also work with Genius/Pro Artillery printers
uses a 0.070" Tack nail in front to hold the circuit board in place, a tooth pick or the like may also work.
Check out my other work at:
smallteamsupply.com
File | Extension |
---|---|
Artillery filament runout sensor housing.STL | STL |
Version: Branded latest
Version: 1.0.0
Initial release
This is a housing and filament guide for Artillery Sidewinder to upgrade the filament runout sensor.
I sourced the sensor from here: https://www.partsbuilt.com/filament-runout-sensor-photoelectric-sidewinder-x1-x2-genius-pro-artillery/
Designed to feed from a bowden tube.
Test printed out of PCTPE
May also work with Genius/Pro Artillery printers
uses a 0.070" Tack nail in front to hold the circuit board in place, a tooth pick or the like may also work.
Check out my other work at:
smallteamsupply.com
1.2K
61
Jan 31, 2023
3D Printer
United States
English
Creative Commons Attribution-NonCommercial 4.0 International
File | Extension |
---|---|
Artillery filament runout sensor housing.STL | STL |
Version: Branded latest
Version: 1.0.0
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.