this is a step file with 4 variations of the Chonky Boi receiver. two fit mil spec uppers and 2 fit bear creek arsenal side charging uppers. some have a spot for a 1/4" 6-32 set screw if you want to make a selector stop so that you don't accidentally go third position on a fudd range.
there is a slot on top where you can drop in a dog tag if you want to serialize your lower, just slide the plug in on top afterwards and use a soldering iron to plastic weld the seam shut.
to assemble the lower you need the following: -4x 2" 6-32 socket head screws (two cut to 1.75" inserted in the bottom 2 holes) (inserted through the back to strengthen the receiver extension) -1x 1" 6-32 socket head screw (for reinforcing the pistol grip) -1x 5/8" 8-32 socket head screw and 8-32 square nut (the nut is inserted in back, and the screw comes through the bottom to keep the buffer tube from turning) -1x 1" 1/4 od screw post (to hold the pistol grip in place) -2x 2" 1/4 od screw posts (to act as pivot and take down pins) -1x 1.5" 3-36 socket head screw (to hold the bolt hold open in place) -1x mil spec mag release -1x mil spec bolt hold open -1x mil spec carbine buffer tube -1x ar15 FCG
File | Extension |
---|---|
AR lower v5 .step | step |
Version: 1.0.0 latest
initial upload
this is a step file with 4 variations of the Chonky Boi receiver. two fit mil spec uppers and 2 fit bear creek arsenal side charging uppers. some have a spot for a 1/4" 6-32 set screw if you want to make a selector stop so that you don't accidentally go third position on a fudd range.
there is a slot on top where you can drop in a dog tag if you want to serialize your lower, just slide the plug in on top afterwards and use a soldering iron to plastic weld the seam shut.
to assemble the lower you need the following: -4x 2" 6-32 socket head screws (two cut to 1.75" inserted in the bottom 2 holes) (inserted through the back to strengthen the receiver extension) -1x 1" 6-32 socket head screw (for reinforcing the pistol grip) -1x 5/8" 8-32 socket head screw and 8-32 square nut (the nut is inserted in back, and the screw comes through the bottom to keep the buffer tube from turning) -1x 1" 1/4 od screw post (to hold the pistol grip in place) -2x 2" 1/4 od screw posts (to act as pivot and take down pins) -1x 1.5" 3-36 socket head screw (to hold the bolt hold open in place) -1x mil spec mag release -1x mil spec bolt hold open -1x mil spec carbine buffer tube -1x ar15 FCG
3.7K
332
Jun 15, 2023
CAD Object, Stereolithic object
United States
English
No license
File | Extension |
---|---|
AR lower v5 .step | step |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.