Tidal Wave Angled Foregrip: FFFTech/FFFTechnology
A basic curved angled foregrip with a handstop towards the front. Has deep ridging along the curved section.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
First Layer Print Height: .18mm
Standard Layer Height: .14mm
Wall Thickness: .40mm
Wall Perimeters: 4 - 5
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 26%
Print the AFG upside down.
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)