PDW S/B, Model 1 Delta 1 V1.0.1: Laffs Dynamics

Enhanced variant of the Base Model 1 Folding PDW Stock/Brace. Includes the Delta 1 styled folding stock/brace arm, and the Enhanced QD Model 1 Folding Hinge Mount. 

Along with the new variant parts, the arm and enhanced mount is mirrored for right side folding; said files are within their applicable folders.

A short length of pull, folding stock/brace. Mounts via 4+ slot picatinny rail. Either a blade style brace, or buttstock can be fitted in the rear socket of the folding arm. 

Update V1.0.1: Redesignated design name.

Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 220C 
Bed: 56C 
First Layer Print Height: .2mm 
Standard Layer Height: .16mm
Wall Thickness: .40 
Wall Perimeters: 5
Infill: 50%
Infill Pattern: Gyroid
Support Material Percentage: 20%

Hardware Needed: 

1x M6x40mm Bolt
1x 8mm x 20mm Spring (Ender 3 Bed Spring)

Notes: 

1) The M6x40mm bolt should simply pass through the hinge of the folding arm. Should the threads cut into the hinge, dremel out the hole slightly until the bolt passes through. The bolt should only thread into the folding mech mount's top and bottom hinge points. Be sure not to overtighten the bolt, otherwise the hinge points could flex and squeeze together, binding the folding arm and not allowing it to articulate. 

2) If the spring is too tight, simply cut off a coil to reduce pressure on the mechanism.