AMPoly Series: Single Glock Mag Carrier V2: FFFTech/FFFTechnology
Version 2 of the AMPoly Series Mag Carriers; specifically this variant is for single Glock mags.
Changed the internal geometry to aid in magazine friction retention, enlarged drain slots, and changed the bendable belt clip to a stronger carrier retaining belt mount.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 4 (6 For the Carrier Retaining Belt Mount)
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Adhesive Used: Clear Gorilla Glue (Not Superglue)
Assembly Directions:
1) Use sandpaper to roughen the tabs of the belt clip.
2) Apply Clear Gorilla Glue to the tab index slots of the mag carrier.
3) Clamp the carrier retaining belt mount to the carrier. Be sure the clip is parallel to the side of the carrier.
4) Wipe away adhesive squeeze-out.
5) Let the adhesive set for 2 hours clamped. Full cure time 24 hours. (But after the 2, I doesn't need to be clamped.)
Notes:
Note 1) The use of Clear Gorilla Glue was chosen to reduce design weight and hardware usage. (No screws needed)
File | Extension |
---|---|
AMPoly Single Glock V2.zip | zip |
Version: 1.0.0 latest
AMPoly Series: Single Glock Mag Carrier V2: FFFTech/FFFTechnology
Version 2 of the AMPoly Series Mag Carriers; specifically this variant is for single Glock mags.
Changed the internal geometry to aid in magazine friction retention, enlarged drain slots, and changed the bendable belt clip to a stronger carrier retaining belt mount.
Printer Used: Monoprice Maker Select Plus
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 4 (6 For the Carrier Retaining Belt Mount)
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Adhesive Used: Clear Gorilla Glue (Not Superglue)
Assembly Directions:
1) Use sandpaper to roughen the tabs of the belt clip.
2) Apply Clear Gorilla Glue to the tab index slots of the mag carrier.
3) Clamp the carrier retaining belt mount to the carrier. Be sure the clip is parallel to the side of the carrier.
4) Wipe away adhesive squeeze-out.
5) Let the adhesive set for 2 hours clamped. Full cure time 24 hours. (But after the 2, I doesn't need to be clamped.)
Notes:
Note 1) The use of Clear Gorilla Glue was chosen to reduce design weight and hardware usage. (No screws needed)
2K
424
Jan 11, 2022
United States
English
QmRtuNPcq3MSZ4SZue4Kb4vkoui5UCpEywURGVjzVF2AtX
File | Extension |
---|---|
AMPoly Single Glock V2.zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.