ARD-1 Grenade Sabot: Laffs Dynamics

A two part sabot for launching Laffs Dynamics ARD-1 Smoke Grenades out of a X Products Can Cannon Upper.

• Printer Used: Ender 3 V2
• Filament Used: PLA+

Print Settings:

• Extruder: 218C
• Bed: 56C 
• First Layer Print Height: .2mm 
• Standard Layer Height: .16mm
• Wall Perimeters: 7+ 
• Infill: 60%+

ARD-1 Grenade source: https://defcad.com/library/15e70f2d-877d-4e54-a0bf-4478657b0e23/

Assembly and Usage: 

1. Place a ARD-1 grenade between 2 sabot shells.
2. Wrap two rubber bands around the sabot's external ridges to keep it together as a single unit during storage and transportation.
3. Before use, remove the protective cap from the top of the grenade. 
4. Insert the sabot/grenade unit into the bore of the Can Cannon, removing the banding keeping the sabot together during transport.  
5. Once seated, quickly light grenade's timed fuse (I suggest using a enlongated "stick" lighter.)
6. Aim, and fire a blank cartridge to launch the grenade. (Be aware the grenade will release smoke and a lot of heat, so no dillydallying.)

Notes: 

1. Before use, be sure you are using an air filtration unit, preferably a gas mask with at least P3 - P3R rated filters Smoke isn't good for your silly lil lungs.
2. The grenades used in conjunction with the two part sabot are not (federally in the United States) illegal, but might not be legal to own within your own country, state, or county.
3. The X Products Can Cannon is not considered a Destructive Device per ATF. That being said, research your local and federal laws before use with the sabot / grenade combination. (I aint ye daddy; won't tell ya what to do.)