# Shield9-ASP2.1 A reimagining of the Devel ASP, but on FMDA's S&W M&P Shield 9. * nguyenkvvn - ASP 2.1 * FreeMenDontAsk - Shield 9 original model ## Description The ASP 2.1 is a modern interpretation of the obscure, rare, and venerable precursor to compact guns- Paris Theodore's ASP, and Charles Kelsey's Devel. It is built off of FMDA's Shield 9 model. Enhancements typically found in the ASP and Devel include: round count window, and front hooked trigger guard. The ASP 2.1 incorporates a canted thumb-rest forward of the frame as well. ## Materials Required You will need a set of each below for each [x] you make. - **Smith and Wesson M&P Shield 9 parts kit** - You can check GunBroker or EveryGunPart. - **Glock or Shield9 magazine spring** - Don't forget your magazine spring! - **Shield 9 Magazine** - And of course, your magazine. ## Materials Recommended Steal that ASP look with these recommended accessories. - **Meprolight FT Bullseye** - Availible in red or green, you can get a similar "no-front-sight" look and function of the gutter-sight from the originals. - **ETS Shield 9 Magazine - clear** - This is one of the transparent magazines you will need for the window to work. - **Front sight delete plate** - This is a printable file to remove the front sight and fill the cutout. ## Instructions 1. Print the frame with the top of the model face down. (Aka, bottom of the grip pointed up) Reccomended tempeatures are: 45mm/s @ 230c; eSun PLA+ is strongly reccomended. 2. (Optional) Print the transparent panel, then salt anneal it to bond all of the layers into a translucent mold. Sand and file until clear. 3. Remove all supports from the model. ## Changelog * Private Beta v0.1 > - Initial beta ## License MIT License.