Storage Grip V2 (AR-15): FFFTech/FFFTechnology

Version 2 of the original 3FTech Storage Grip. Overall a longer and wider design. Overall grip width is 29.3mm, length is roughly 107mm. The V2 can hold 17 - 18 rounds of 9x19 NATO, versus the V1's capacity being only 10 - 11 rounds. 

The storage hatch for V2 has been significantly strengthened compared to V1.

Has two different textured locking tab hatches. 

Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 220C 
Bed: 56C 
First Layer Print Height: .20mm 
Standard Layer Height: .16mm
Wall Thickness: .40 
Wall Perimeters: 7+
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18% 

Hardware Needed:

1x Allen Head Screw, 1/4-28 x 1"

1x Steel Star Washer

1x Safety Selector Detent Pin

1x Safety Selector Detent Spring

1x M3x12mm (or M3x15mm) Hex Set Screw

Notes: 

1) Yes... I checked it's Skittle capacity; Storage Grip V2 can hold roughly a little over half a standard pack of Skittles. 

Accreditations:

theOtherSig: Printed and assembled the grip. Gave info that led to an improved lockup of the tabs to the inside of the grip, as well as provided info for geometric edits to make hatch closure easier than previously designed. Provided video footage and images.

EWW: Printed and assembled the grip. Provided footage and images. Provided info on 9x19 Nato capacity. (Somehow performed black magic fuckery and fit 19rds, max I could fit was 17.)