Got tired of the janky bolt and o-ring on the BCA uppers so I made a perfectly clocked plug. It is to be used without the clip to be clocked correctly.
*I was only able to test on a 7.62x39 and the .300 model uppers but all my research says its at least the same thread pitch. It clocked the same on both my uppers.*
Next is the clip, which is to replace the o-ring and properly clock the bolt. Same starred disclaimer applies here. It worked on mine but I can't gaurentee it will work on yours.
Check out my BCA charging handles too!
File | Extension |
---|---|
BCA Hardware/Screw.stl | stl |
BCA Hardware/Clip.stl | stl |
Version: 1.0.0 latest
initial upload
Got tired of the janky bolt and o-ring on the BCA uppers so I made a perfectly clocked plug. It is to be used without the clip to be clocked correctly.
*I was only able to test on a 7.62x39 and the .300 model uppers but all my research says its at least the same thread pitch. It clocked the same on both my uppers.*
Next is the clip, which is to replace the o-ring and properly clock the bolt. Same starred disclaimer applies here. It worked on mine but I can't gaurentee it will work on yours.
Check out my BCA charging handles too!
953
127
Jul 7, 2023
Stereolithic object, Printable project
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International
File | Extension |
---|---|
BCA Hardware/Screw.stl | stl |
BCA Hardware/Clip.stl | stl |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.