Creator: db-firearms
V1: Initial Release
V1.1: updated to support raised AB (thanks Dogenado)
This is a brace end (loosely copied from a strike industries brace) designed to fit on a JMAC AB. It uses the cross hinge pin to secure to the AB. It requires some M6 hardware.
This was designed using a clone brace, so I am hoping to get some feedback on a real JMAC AB to make sure it's fully compatible. Please provide feedback so I can make it better
File | Extension |
---|---|
DBs JMAC AB Brace End Beta 1.1.zip | zip |
Version: 1.1.0 latest
initial upload
Creator: db-firearms
V1: Initial Release
V1.1: updated to support raised AB (thanks Dogenado)
This is a brace end (loosely copied from a strike industries brace) designed to fit on a JMAC AB. It uses the cross hinge pin to secure to the AB. It requires some M6 hardware.
This was designed using a clone brace, so I am hoping to get some feedback on a real JMAC AB to make sure it's fully compatible. Please provide feedback so I can make it better
577
178
Mar 29, 2024
United States
English
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International
File | Extension |
---|---|
DBs JMAC AB Brace End Beta 1.1.zip | zip |
Version: 1.1.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.