Note: these blueprints are for an older version of our clamp. Version B of the clamp does not yet have published blueprints, but our 3D model on DEFCAD reflects the newer Version B.
Blueprints for Version A the 1.5" clamps used in the Ghost Gunner's to hold the AR-15 Non-Receiver Block for milling into a Zero Percent Receiver. They are designed to securely hold a piece of 1.5" metal bar stock.
A 3D model of Version B of this item can be found here.
File | Extension |
---|---|
Clamp Assembly Drawing and BOM revA.pdf | |
CLAMP-05 - Insulating Washer revA.pdf | |
CLAMP-04 - Insulating Pad revA.pdf | |
CLAMP-03 - Jaw revA.pdf | |
CLAMP-02 - Insert revA.pdf | |
CLAMP-01 - Body revA.pdf |
Version: 1.0.0 latest
Note: these blueprints are for an older version of our clamp. Version B of the clamp does not yet have published blueprints, but our 3D model on DEFCAD reflects the newer Version B.
Blueprints for Version A the 1.5" clamps used in the Ghost Gunner's to hold the AR-15 Non-Receiver Block for milling into a Zero Percent Receiver. They are designed to securely hold a piece of 1.5" metal bar stock.
A 3D model of Version B of this item can be found here.
3.3K
943
Jan 07, 2024
Mill
United States
English
No license
QmYxP758u7zYNHmobagvAKL5Tdcda9xTk5tYxh9YGHQcvH
File | Extension |
---|---|
Clamp Assembly Drawing and BOM revA.pdf | |
CLAMP-05 - Insulating Washer revA.pdf | |
CLAMP-04 - Insulating Pad revA.pdf | |
CLAMP-03 - Jaw revA.pdf | |
CLAMP-02 - Insert revA.pdf | |
CLAMP-01 - Body revA.pdf |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.