A m-loc compatible handguard cutting fixture for ~48mm (1.875in) od tubes
Includes clamps with a center notch for a datum pt
shop vac plug for dust removal (tape existing cut slots to maintain suction)
Indexing ring, use a square or level and index for every cut and then tighten the clamps
Tube included so you can generate a toolpath from it or print it as a template and go to town with a dremel
I have successfully cut 5 handguards of various lengths on a original mpcnc with an 1/8 cutter on this fixture.
You must have good dust collection!
File | Extension |
---|---|
heat tube.rar | rar |
Version: 1.0.0 latest
initial upload
A m-loc compatible handguard cutting fixture for ~48mm (1.875in) od tubes
Includes clamps with a center notch for a datum pt
shop vac plug for dust removal (tape existing cut slots to maintain suction)
Indexing ring, use a square or level and index for every cut and then tighten the clamps
Tube included so you can generate a toolpath from it or print it as a template and go to town with a dremel
I have successfully cut 5 handguards of various lengths on a original mpcnc with an 1/8 cutter on this fixture.
You must have good dust collection!
308
91
Oct 15, 2024
United States
English
No license
File | Extension |
---|---|
heat tube.rar | rar |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.