Close Quarters Evo Grip (CZ Scorpion Evo 3): Laffs Dynamics
A large, curved, forward angle grip for use in close quarters engagements. Has .5mm wrap ridging around the front section.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
1x M4 Hex Nut
File | Extension |
---|---|
Close Quarters Evo Grip.zip | zip |
Version: 1.0.0 latest
Initial release
Close Quarters Evo Grip (CZ Scorpion Evo 3): Laffs Dynamics
A large, curved, forward angle grip for use in close quarters engagements. Has .5mm wrap ridging around the front section.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
1x M4 Hex Nut
1K
98
Jul 18, 2022
3D Printer
United States
English
QmPsTpqMMB9bcyWheAepqtBjfVhvErxsSX3nZTgcEgEk81
File | Extension |
---|---|
Close Quarters Evo Grip.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.