DYNAMIC DONG (Circumcised) M-Lok AFG: FFFTech/FFFTechnology

A foregrip that mimics the PM md. 63's unique forward-pointing front handgrip, known to many as the "Dong" grip, except people seem to like cutting these partially off... you could say *just the tip*.

Instead of cutting off the foresk- I mean the end of the foregrip off, this has been designed to already have a short, slanted bottom. And since this is much shorter than the original DYNAMIC DONG, I can legally call this an angled foregrip without the ATF being a bunch of basic bitches about it. 

IT"S ANGLED FORWARD, FED BOIS!

This design is created to mount to M-Lok, essentially allowing attachment to any compatible forend on AKs; and any other weapons with M-Lok slotted forends.

Printer Used: Monoprice Maker Select Plus

Filament Used: PLA+

Print Settings:

Extruder: 218C 
Bed: 55C 
First Layer Print Height: .18mm 
Standard Layer Height: .14mm
Wall Thickness: .40 
Wall Perimeters: 4 - 5
Infill: 22%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 30%

Print the cut dong upside down. 

Hardware Required:

2x M5x10 Hex Socketed Machine Screw/Bolt

2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)