Dynamic Dong Mini-PR (Angled Foregrip)
about
Dynamic Dong Mini-PR (Angled Foregrip): Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .12
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 36%+
Support Material Percentage: 18%
Print the AFG upside-down.
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
files
| File | Extension |
|---|---|
| Dynamic Dong Mini-PR.zip | zip |
versions
Version: 1.0.0 latest
initial upload
about
Dynamic Dong Mini-PR (Angled Foregrip): Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .12
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 36%+
Support Material Percentage: 18%
Print the AFG upside-down.
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
creator
Metrics
Views
1.6K
Downloads
216
Project Info
release date
Jun 05, 2023
artifact type
library category
fabrication method
release country
United States
language
English
license
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
files
| File | Extension |
|---|---|
| Dynamic Dong Mini-PR.zip | zip |
versions
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
