HulkHoganHH's semi auto vz61 receiver
Designed by HulkHoganHH (discord:HulkHoganHH#2447, [email protected])

Intermediate hand tool skills required
I take no responsibility for any criminal activity committed with these files and will deny any involvement with any criminal parties. Be familiar with local laws before manufacturing. Any trouble you get into is your fault.

PLA Plus/pro is the material recommended for this build

---DO NOT PRINT IN PETG---

print on its side, engravings upward.

This design has successfully survived a full magazine dump with no signs of stress found (PLA+)

---Materials---
4mm OD steel pins
1/8" OD steel pins
A vz61 parts kit
    -When buying a kit, be sure that you are buying a kit with a barrel and sights already installed as these are not easy to install without proper tools.

---Tools needed---
m15x1-h2 metric tap
flat file
triangular (equilateral) file if you decide to add the stock
metric drill set
1/8" OD drill
dremel for quicker sanding
drill press with vise recommended for handle hole threading

---Where to drill? (recommended depending on printer)---
The two 4mm holes for the hammer and trigger
the 5mm takedown hole in the front
the 9mm hole for the magazine catch/button (clean this hole well to prevent sticking)
the 3mm hole in the middle section of the receiver (be very careful to not drill all the way through, however if you do you can tap and plug the hole with a short screw)
the 4mm hole for the bolt hold open (clean well to prevent sticking)
the two 1/8" holes next to the takedown hole in the front of the receiver (if reinforcing with steel pins)