A DIY 9mm semi-automatic pistol which combines an upper receiver made from 1.75” OD x 0.095” Wall Round Tube with an AP9/FGC-9 type Glock magazine compatible lower receiver.
The bolt is made from 1.5” steel bar using a drill and an angle grinder. A welder is required to complete the upper receiver.
Includes a 38 page PDF construction guide.
File | Extension |
---|---|
STRUG v1.rar | vnd.rar |
Version: 1.0.0 latest
Initial release
A DIY 9mm semi-automatic pistol which combines an upper receiver made from 1.75” OD x 0.095” Wall Round Tube with an AP9/FGC-9 type Glock magazine compatible lower receiver.
The bolt is made from 1.5” steel bar using a drill and an angle grinder. A welder is required to complete the upper receiver.
Includes a 38 page PDF construction guide.
15.3K
1.1K
Jul 05, 2022
3D Printer, Angle Grinder
English
No license
QmT1RwaYyLoreUZUoRjkhhAm5HgwK3FAb93dao6FfvpsEp
File | Extension |
---|---|
STRUG v1.rar | vnd.rar |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.