# TMS-94 3D printable frame for the FNH FNS-9 and FNS-40 pistols. by TM18271998 and nguyenkvvn ## Description This frame is compatible with full size and long-slide parts kits for FNS pistols. This only requires a complete lower frame completion kit, and a slide assembly. It is NOT compatible with interchangable backstraps, or a manual safety. ## Variants - **Full Size** - For full-size magazines and full-size slides. - **Compact** - For compact magazines and compact slides. - **Chode** - For full-size magazines and compact slides. - **Stubby** - For compact magazines and full-size slides. - **Longslide** - For full-size magazines and Longslides, by Skinnypew. > **Does your parts kit have a safety?** If so, you will need to go to nguyenkvvn's variant that accomodates this feature, which can be found in the "Beta Tester Remixes" folder. ## Materials Required You will need a set of each below for each pistol you make. - x1 **Complete FNS Slide Assembly** - (Slide, barrel, recoil assembly, slide internals) - x1 **Complete FNS Lower Completion Parts Kit** - (Trigger, rear assembly, slide catch, disassembly lever, locking block, front frame pin, rear frame pin, trigger pin, slide lock spring, Z-spring) - x1 **FNS magazine** - of your choice in caliber and size. ## Tooling Required - x1 4mm drill bit - x1 hammer - x1 2 - 4mm pin punch - x1 2.5mm roofing nail and vise grip (optional) **Note:** All lower parts kits are the same between calibers.