Shark Fin M-Lok Handstop
about
Shark Fin M-Lok Handstop: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 38%
Support Material Percentage: 26%
Print the handstop upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
files
| File | Extension |
|---|---|
| Shark Fin M-Lok Handstop.zip | zip |
versions
Version: 1.0.0 latest
Initial release
about
Shark Fin M-Lok Handstop: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 38%
Support Material Percentage: 26%
Print the handstop upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
creator
Metrics
Views
1.6K
Downloads
248
Project Info
release date
Feb 22, 2023
artifact type
library category
fabrication method
fabrication tool
3D Printer
release country
United States
language
English
license
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
files
| File | Extension |
|---|---|
| Shark Fin M-Lok Handstop.zip | zip |
versions
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
