A fixed buttstock, derived from the FBS-1 (AKM) buttstock design.
Overall length has been shortened to 250.8mm. For use by people that require a shorter LOP.
(The fembois need AKs too ye know :3)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 34%
Support Material Percentage: 20%
Hardware Needed:
2x M4x12mm Screws
File | Extension |
---|---|
FBS-3 (AKM) V1.0.1.zip | zip |
Version: FBS-3 (AKM) V1.0.1 latest
FBS-3 (AKM) V1.0.1: Laffs Dynamics
A fixed buttstock, derived from the FBS-1 (AKM) buttstock design.
Overall length has been shortened to 250.8mm. For use by people that require a shorter LOP.
(The fembois need AKs too ye know :3)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 34%
Support Material Percentage: 20%
Hardware Needed:
2x M4x12mm Screws
Version: 1.0.0
Initial release
A fixed buttstock, derived from the FBS-1 (AKM) buttstock design.
Overall length has been shortened to 250.8mm. For use by people that require a shorter LOP.
(The fembois need AKs too ye know :3)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 34%
Support Material Percentage: 20%
Hardware Needed:
2x M4x12mm Screws
1.7K
202
Jun 07, 2023
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
FBS-3 (AKM) V1.0.1.zip | zip |
Version: FBS-3 (AKM) V1.0.1 latest
FBS-3 (AKM) V1.0.1: Laffs Dynamics
A fixed buttstock, derived from the FBS-1 (AKM) buttstock design.
Overall length has been shortened to 250.8mm. For use by people that require a shorter LOP.
(The fembois need AKs too ye know :3)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 34%
Support Material Percentage: 20%
Hardware Needed:
2x M4x12mm Screws
Version: 1.0.0
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.