FS-1 Rev 1
about
FS-1 Rev 1: Laffs Dynamics
Revision of the original Laffs Dynamics FS-1 picatinny attachable buttstock. Much beefier than the original design; extra material around the mounting section, much less material internally towards the rear.
Comes in two variants; a four slot mount and five slot taking advantage of some firearms having more picatinny rail space.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16
Wall Thickness: .40
Wall Perimeters: 7+
Infill: 40%+
Support Material Percentage: 18%
(Use infill blockers on the inside of the buttstock, as it is semi-hollow.)
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
files
| File | Extension |
|---|---|
| FS-1 Rev 1.zip | zip |
versions
Version: 1.0.0 latest
initial upload
about
FS-1 Rev 1: Laffs Dynamics
Revision of the original Laffs Dynamics FS-1 picatinny attachable buttstock. Much beefier than the original design; extra material around the mounting section, much less material internally towards the rear.
Comes in two variants; a four slot mount and five slot taking advantage of some firearms having more picatinny rail space.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16
Wall Thickness: .40
Wall Perimeters: 7+
Infill: 40%+
Support Material Percentage: 18%
(Use infill blockers on the inside of the buttstock, as it is semi-hollow.)
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
creator
Metrics
Views
937
Downloads
129
Project Info
release date
Jan 30, 2024
artifact type
library category
fabrication method
fabrication tool
3D Printer
release country
United States
language
English
license
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
files
| File | Extension |
|---|---|
| FS-1 Rev 1.zip | zip |
versions
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
