Glock 17 Gen 5 Picatinny Adaptor Rail by FFFTech/FFFTechnology

(Will only fit Gen 5 Glock Rails)

A five slot picatinny rail that attaches to the Glock 17 Gen 5 proprietary rail. While most picatinny compatible accessories will fit on the Glock rail, the single slot limits the options when one wishes to mount accessories forward or back along the rail. The rail extends all the way to the front of the triggerguard.

Printer Used: Monoprice Maker Select Plus

Filament Used: PLA+

Print Settings:

Extruder: 204C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 3
Infill: 25%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 10%

Support material only for the rail slots directly above the print bed.

Hardware Needed:

1x M6x8mm Hex Socketed Set Screw (Be sure the end is beveled!)

Installation:

1) After support material removal, slide the picatinny adaptor over the Glock Rail.

2) Hold the rail to it's rearmost position and start threading the set screw into the adaptor.

3) Drive the set screw flush with the bottom of rail slot. Check every 2 screw revolutions to see if the rail adaptor is properly secure.

4) Once secure, attach dem bomb diggity accessories.