"Get Bent" Stubby AFG: FFFTech/FFFTechnology
A stubby, angled foregrip. Comes in two versions: Textured & Standard.
To be clear: This is NOT a VERTICAL foregrip, I designed it to have a distinct grip angle of 65.4°;
not like a vertical foregrip of 90°.
This IS an ANGLED foregrip. Angled foregrips as of 2021, still can be attached to pistols legally.
Vertical foregrips cannot.
Again... it's an ANGLED FOREGRIP, as in NOT VERTICAL.
Update V1.1.2: Enlarged picatinny rail channel for better fitment, organized files to current 3FTech data pack format, changed print settings for the common used Ender 3 3D printers. (Oh god... this old text ^ is kinda cringe)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 20%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print upside-down, using support material only for the rail slot.
Hardware Needed:
1x M5x30 Hex Socketed Machine Screw/Bolt
1x M5 Hex Nut (Be sure both bolt & nut are the same thread pitch.)
File | Extension |
---|---|
Get Bent AFG V1.1.2.zip | zip |
Version: 1.0.0 latest
"Get Bent" Stubby AFG: FFFTech/FFFTechnology
A stubby, angled foregrip. Comes in two versions: Textured & Standard.
To be clear: This is NOT a VERTICAL foregrip, I designed it to have a distinct grip angle of 65.4°;
not like a vertical foregrip of 90°.
This IS an ANGLED foregrip. Angled foregrips as of 2021, still can be attached to pistols legally.
Vertical foregrips cannot.
Again... it's an ANGLED FOREGRIP, as in NOT VERTICAL.
Update V1.1.2: Enlarged picatinny rail channel for better fitment, organized files to current 3FTech data pack format, changed print settings for the common used Ender 3 3D printers. (Oh god... this old text ^ is kinda cringe)
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .14mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 20%
Infill Pattern: Gyroid
Material Flow: 100%
Support Material Percentage: 18%
Print upside-down, using support material only for the rail slot.
Hardware Needed:
1x M5x30 Hex Socketed Machine Screw/Bolt
1x M5 Hex Nut (Be sure both bolt & nut are the same thread pitch.)
5.3K
627
QmXUbRd5kGZDsfFn2VYCBxggLtsBqdSDvXnkwWZuY1AGRV
File | Extension |
---|---|
Get Bent AFG V1.1.2.zip | zip |
Version: 1.0.0 latest
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.