Glock43 Light Up Stand

These files are oriented properly in cura. You should be able to print

this vertically without using supports for the round spots. The 6 holes on top will 

hold x6 - 9mm rounds while omitting your light up through the bullet. The hole in the 

back is designed for a short light strip. Im using a 3ft usb powered controlled rgb 

led that I cut down. I found this at my local $5 below but amazon has them also!

Print the Back piece using a highter infill because it can tear in half after removing it a bunch.

Its best to insert it once and be finished once your satisfied with your lighting. 

++++++++++++++++++++++++++++++++++++++++++++++++
NeutronNickandSpaceBoundTactical    

Print Settings
Esun or Inland Brand PLA PLUS+++ preferred
Nozzle 220
Bed 62    
++++++++++++++++++++++++++++++++++++++++++++++++

++++++++++++++++++++++++++++++++++++++++
reddit u/Spaceboundtactical
Odysee SpaceboundTactical
DefCad Spaceboundtactical

https://twitter.com/SpaceBound3DP

Feel Free to share your prints!!