A ‘STEN’ type 9mm submachine gun which fires from an open-bolt and uses 1.5” x 0.065 (38.1mm x 1.6mm) Steel Round Tube combined with a Glock magazine accepting 3D printed lower Receiver. The bolt is fabricated from steel bar stock (Using an angle grinder and a drill) and uses a recoil spring found inside a lever type grease applicator gun. The barrel can either be turned as a single piece on a lathe or assembled from shaft lock collars and steel tubing.
The materials used in this version are more widely available and the gun will have a lower Rate Of Fire.
Includes a 36 page construction guide PDF
File | Extension |
---|---|
Hybrid Printed Round Tube SMG.rar | rar |
Version: 1.0.0 latest
Initial release
A ‘STEN’ type 9mm submachine gun which fires from an open-bolt and uses 1.5” x 0.065 (38.1mm x 1.6mm) Steel Round Tube combined with a Glock magazine accepting 3D printed lower Receiver. The bolt is fabricated from steel bar stock (Using an angle grinder and a drill) and uses a recoil spring found inside a lever type grease applicator gun. The barrel can either be turned as a single piece on a lathe or assembled from shaft lock collars and steel tubing.
The materials used in this version are more widely available and the gun will have a lower Rate Of Fire.
Includes a 36 page construction guide PDF
8.4K
600
Jun 26, 2022
3D Printer, Angle Grinder, Power Drill
United States
English
No license
QmTHoQ7RZ6V4uyuPJwXhv7YtBxxeqyy4HGKsGLHF2wLhfQ
File | Extension |
---|---|
Hybrid Printed Round Tube SMG.rar | rar |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.