Laffs M-Lok Slot Covers: Laffs Dynamics
Basic bitch M-Lok slot covers, tapered and rounded for comfort in the hand.
Comes in three variants:
*3 Slot
*2 Slot
*1 Slot
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm - .20mm
Wall Thickness: .40mm
Wall Perimeters: 4+
Infill: 25%
Support Material Percentage: 18%
Print the AFG upside down.
Use support blockers; as the inside of the foregrip is semi-hollow.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
(Only one of each hardware part needed for the single slot cover.)
File | Extension |
---|---|
Laffs M-Lok Slot Covers.zip | zip |
Version: 1.0.0 latest
Initial release
Laffs M-Lok Slot Covers: Laffs Dynamics
Basic bitch M-Lok slot covers, tapered and rounded for comfort in the hand.
Comes in three variants:
*3 Slot
*2 Slot
*1 Slot
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm - .20mm
Wall Thickness: .40mm
Wall Perimeters: 4+
Infill: 25%
Support Material Percentage: 18%
Print the AFG upside down.
Use support blockers; as the inside of the foregrip is semi-hollow.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
(Only one of each hardware part needed for the single slot cover.)
2.4K
297
Aug 16, 2022
3D Printer
United States
English
QmPSWKqQqEYcGK2XtajosQ8bx7ibdmz6MHx9Bx3Y65mfGJ
File | Extension |
---|---|
Laffs M-Lok Slot Covers.zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.