WarFairy Arms M14 Magazine
#### Description
Its a M14 magazine, not a whole lot to say about it.
#### Instructions
* You will need sandpaper or steel wool for surface finishing.
* Print all magazine bodies from back to front, support material on. When cleaning support structures away, pay special attention to the inside surface of the feed lips to ensure smooth dispensing of ammunition.
* For restricted capacity magazines, you will need the follower with the mag block cut.
* All magazines use the same base plate and require an M14 magazine spring.
* Bolt hold open does NOT work with any of these magazines.
As always, follow local laws when printing magazines.
File | Extension |
---|---|
M14_Warrior_Fae_v2_Magazine-Shanrilivan.zip | zip |
Version: 1.0.0 latest
initial upload
WarFairy Arms M14 Magazine
#### Description
Its a M14 magazine, not a whole lot to say about it.
#### Instructions
* You will need sandpaper or steel wool for surface finishing.
* Print all magazine bodies from back to front, support material on. When cleaning support structures away, pay special attention to the inside surface of the feed lips to ensure smooth dispensing of ammunition.
* For restricted capacity magazines, you will need the follower with the mag block cut.
* All magazines use the same base plate and require an M14 magazine spring.
* Bolt hold open does NOT work with any of these magazines.
As always, follow local laws when printing magazines.
1K
411
Feb 1, 2024
3D Printer
United States
English
No license
File | Extension |
---|---|
M14_Warrior_Fae_v2_Magazine-Shanrilivan.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.