Mac N' Cheese V1.5 Safety Detent Reciever Fix: Laffs Dynamics
Ok, so I know I may be making a bigger deal of this than I should, but I can't stand the issue that is the missing port for the safety detent
to engage the safety lever in the original lower receiver design. I've asked multiple colleagues and some of my followers; all of which could not give a gfood answer as to why it's missing.
Is it a dealbreaker for most to print it? Probably not.
But it is to me. Frankly without the detent, the safety just kinda... slides in it's pivot point. I don't like that. Too easy to disengage it.
I don't like that.
So here. Not much of a design variant, but at least I don't have to think about it anymore.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 8+
Infill: 80%+
Support Material Percentage: 20%
Notes:
1) This data pack is just for printing the lower receiver. To get the base firearm data pack, use the following link:
(https://odysee.com/@MiddletonMade:1/MacnCheesev15:d)
Credits:
MiddletonMade: Original designer of the Mac N' Cheese 3DP PCC.
File | Extension |
---|---|
Mac N' Cheese V1.5 Safety Detent Reciever Fix.zip | zip |
Version: 1.0.0 latest
initial upload
Mac N' Cheese V1.5 Safety Detent Reciever Fix: Laffs Dynamics
Ok, so I know I may be making a bigger deal of this than I should, but I can't stand the issue that is the missing port for the safety detent
to engage the safety lever in the original lower receiver design. I've asked multiple colleagues and some of my followers; all of which could not give a gfood answer as to why it's missing.
Is it a dealbreaker for most to print it? Probably not.
But it is to me. Frankly without the detent, the safety just kinda... slides in it's pivot point. I don't like that. Too easy to disengage it.
I don't like that.
So here. Not much of a design variant, but at least I don't have to think about it anymore.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40
Wall Perimeters: 8+
Infill: 80%+
Support Material Percentage: 20%
Notes:
1) This data pack is just for printing the lower receiver. To get the base firearm data pack, use the following link:
(https://odysee.com/@MiddletonMade:1/MacnCheesev15:d)
Credits:
MiddletonMade: Original designer of the Mac N' Cheese 3DP PCC.
1.1K
92
Jan 30, 2024
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
Mac N' Cheese V1.5 Safety Detent Reciever Fix.zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.