Mag Pull for 9mm PMags (TPU)
about
My Stanag version worked so well I thought I'd try to make more compatibility. Here's one that fits 9mm PMags. It will probably fit other 9mm stick mags and for now you should be able to just scale the model to fit others. Feel free to reach out if you get a confirm fitment or have any other concerns/recommendations!
These can be printed without supports and seem to work very well printed in 95a TPU. To install them on the PMags, I pushed the "pull tab" to the side and slid them down the mag from the open end of the mag and then worked the loop around the baseplate part. It's a tight fit and they definately wont come off unintentionally.
files
| File | Extension |
|---|---|
| 9mm PMag Mag Pull.stl | stl |
versions
Version: 1.0.0 latest
initial upload
about
My Stanag version worked so well I thought I'd try to make more compatibility. Here's one that fits 9mm PMags. It will probably fit other 9mm stick mags and for now you should be able to just scale the model to fit others. Feel free to reach out if you get a confirm fitment or have any other concerns/recommendations!
These can be printed without supports and seem to work very well printed in 95a TPU. To install them on the PMags, I pushed the "pull tab" to the side and slid them down the mag from the open end of the mag and then worked the loop around the baseplate part. It's a tight fit and they definately wont come off unintentionally.
creator
Metrics
Views
910
Downloads
51
Project Info
release date
Jan 17, 2025
artifact type
library category
fabrication method
release country
United States
language
English
license
files
| File | Extension |
|---|---|
| 9mm PMag Mag Pull.stl | stl |
versions
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.
