Origin Grip (CETME-C): Laffs Dynamics
First of Laffs Dynamics made CETME-C grips. Finger grooved front section with a rounded backstrap.
Max width: 29.4mm
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Perimeters: 8+
Infill: 50%+
Infill Pattern: Gyroid
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Needed:
1x CETME Grip Screw
File | Extension |
---|---|
Origin Grip (CETME C).zip | zip |
Version: 1.0.0 latest
Initial release
Origin Grip (CETME-C): Laffs Dynamics
First of Laffs Dynamics made CETME-C grips. Finger grooved front section with a rounded backstrap.
Max width: 29.4mm
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Perimeters: 8+
Infill: 50%+
Infill Pattern: Gyroid
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Needed:
1x CETME Grip Screw
1.5K
134
Nov 09, 2022
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
File | Extension |
---|---|
Origin Grip (CETME C).zip | zip |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.