Railed Forend (Nameless 37mm Launcher): Laffs Dynamics
Picatinny railed forend for the Nameless 37mm Launcher. The original design utilizes a bottom M-Lok rail interface, this version allows for
greater variety of accessory attachment.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm+
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 38%+
Support Material Percentage: 18%
The rest of the needed files for the launcher can be found here: https://odysee.com/@AreWeCoolYet:7/AWCY-Presents--The-37mm-Nameless-v1.0:4
Accreditations:
DannyMeatball: Lead designer of the AWCY Nameless 37mm Flare Launcher.
File | Extension |
---|---|
Railed Forend (Nameless 37mm).zip | zip |
Version: 1.0.0 latest
initial upload
Railed Forend (Nameless 37mm Launcher): Laffs Dynamics
Picatinny railed forend for the Nameless 37mm Launcher. The original design utilizes a bottom M-Lok rail interface, this version allows for
greater variety of accessory attachment.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .16mm+
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 38%+
Support Material Percentage: 18%
The rest of the needed files for the launcher can be found here: https://odysee.com/@AreWeCoolYet:7/AWCY-Presents--The-37mm-Nameless-v1.0:4
Accreditations:
DannyMeatball: Lead designer of the AWCY Nameless 37mm Flare Launcher.
1.7K
85
Feb 1, 2024
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-NoDerivatives 3.0
File | Extension |
---|---|
Railed Forend (Nameless 37mm).zip | zip |
Version: 1.0.0 latest
initial upload
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.