A surefire Scout light mount designed to mimic that of the T.REX Arms Lightbar, but printable. The Lightbar's primary purpose is to extend the light so that you don't have as much flood on your suppressor by pushing the light forward further than what your handguard would normally allow. The original design was made out of aluminum (and was also $45 lmao), but I specifically went through four iterations of destructive testing and design reinforcement to bring it up to scuff to be a proper alternative.

It's intended to be printed in either GF or CF-Nylon for maximum strength and heat resistance against what radiates off of a hot suppressor. You might be able to get away with PLA+ if you are not putting this on a 5.56 or 300BLK, but I haven't tested PLA+ mounts for heat deformation, and they won't be as strong.

Tested and mounts to: Streamlight HLX, Goonbeam Long, and the Surefire Scout Light. It should work with any other light that takes that mounting system.