Sheath for Tod Cutler Swiss German Baselard dagger TC55
https://todcutler.com/collections/medieval-daggers-and-large-knives/products/swiss-german-baselard-dagger
Sweet knife, hated the floopy leather sheath so I made this instead.
Print two copys, the sides are reversable, no need to mirror.
Hardware needed:
Qty 4) 10-24 x 5/16 hex hut
Qty 4) 10-24 x 3/8 82 degree flat head screws
Make a frog for it. Or simply wrap a piece of string or webbing around it near the mouth, terminate it into a loop, and slip your belt through that loop.
File | Extension |
---|---|
baselard scabbard knife sheath v2.0.STL | STL |
Version: 1.0.0 latest
Initial release
Sheath for Tod Cutler Swiss German Baselard dagger TC55
https://todcutler.com/collections/medieval-daggers-and-large-knives/products/swiss-german-baselard-dagger
Sweet knife, hated the floopy leather sheath so I made this instead.
Print two copys, the sides are reversable, no need to mirror.
Hardware needed:
Qty 4) 10-24 x 5/16 hex hut
Qty 4) 10-24 x 3/8 82 degree flat head screws
Make a frog for it. Or simply wrap a piece of string or webbing around it near the mouth, terminate it into a loop, and slip your belt through that loop.
1.3K
59
Dec 27, 2022
3D Printer
United States
English
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International
File | Extension |
---|---|
baselard scabbard knife sheath v2.0.STL | STL |
Version: 1.0.0 latest
Initial release
The files shown on this site are only available to U.S. Persons, as defined at 22 C.F.R. 120.15. The files are also not available to persons outside the United States or to residents of and persons in the State of New Jersey, with the exception of Federal Firearms Licensees.